How to setup ETH link type-PPPOE


Model number: D1201

This article will guide you how to setup Tenda D1201 PPPoE of ETH link type and the steps as below.

Part 1: Connect the devices

Part 2: Configure your computer

Part 3: Setup the router

Part 4: Check whether you can access internet

 

When PPPOE of ETH link type mode is enabled, D1201 works as a wireless router.

1.   Connect the Ethernet cable with the WAN port of D1201, and then connect your computer with LAN port of D1201 by a cable.

1. Click on Network Connection Icon on the system bar, then click on Open Network and Sharing Center.

2. Click on Change adapter settings.

3. Right click on Local Area Connection, then choose the Properties option.

4. Double click on Internet Protocol Version 4(TCP/IPv4).

5. Choose Obtain an IP address automatically and Obtain DNS server address automatically and then click OK.

 

说明: D:\桌面\无线\自动获取.png

6 Also click on OK on the first Local Connection Properties window.

3.1 Open a browser then type 192.168.1.1 in the Address bar, click on Enter.

20150425152857.jpg

3.2 Choose ETH option, choose connection type as PPPOE, and then input username and password are given by your ISP.

3.3 Change 2.4G/5G wireless SSID and wireless password as you want, and then click OK to save all the settings.

 

4.1 If connection status shows Connected that means you can access internet, please check.

Was this article helpful to you?

Very Good(5)Article Views(1809)