AP4-How to setup the Client+ AP mode.

How to setup the Client+AP mode?

Model number: AP4

There are five operation mode for this CPE. This mode is very similar to universal repeater mode, in which the AP can extend the WiFi range of uplink ADSL modem or router by relaying wireless signal.

Part 1: Connect the device

Part 2: Set up the WISP mode

Part 3: Check whether you can access internet

Connect one of the port to the router which can access internet, then connect your computer with the other LAN ports of the router by a cable. Or you can connect it via Wifi.

Note: After connection the SYS light should be blinking, the WLAN light should be on or blinking.

1 A wireless access point can’t provide the IP address for your computer.

You should set an IP address for your computer manually before login to the homepage of the AP. The default IP address of this AP is, so the IP address of your computer should be 192.168.0.XXX (1<=XXX<=253).

Open a browser then type in address bar, click Enter.

Note: if you cannot login the home page, please click HERE

2 Fill in user name and password as admin/admin, and choose the country. click Login to login.

1 choose Quick Setup—Client+AP, then click Next.

2 open Scan and choose the remote router’s SSID, click Next.


3 Confirm the remote AP’s info and type in the security key of the remote router. Then click Next.

4 please configure AP4/AP5’s SSID, security mode and WiFi password. Then click Next.

5. This page we can configure IP address of the AP. But we have to make sure the IP address is different from remote AP’s address, but in the same network segment.

Such as if the remote router’s IP address is, we have to change this AP’s IP address to


6 click save, you will see the AP reboot.



The “bridge” light will be on if you configure the AP successfully.

Use your laptop or mobile phone to connect the wireless SSID, then type in the password to access the internet.

Was this article helpful to you?

Very Good(8)Article Views(3024)