how to establish the private network of P1001P

1  Two powerline adapters establish the private network.

n  For examplePowerline adapter 1, powerline adapter 2, establish the private network.

The steps of setting:

? Please keep pressing the Pair/Reset button of powerline adapter 1 for 1~3 seconds, the PLC light will blink.

? Please keep pressing the Pair/Reset button of powerline adapter 2 for 1~3 seconds in 2 minutes, the PLC light will blink.  When PLC light of two powerline adapters changes into bright state normally, they establish the powerline network successfully.

2  The powerline adapter adds the private network having been established.

n  For example: If the powerline adapter 1 and adapter 2 have established the private network N1, you want to add the powerline adapter 3 into N1.

The steps of setting:

? Please keep pressing the Pair/Reset button of the powerline adapter, 3 for 1~3 seconds, its  PLC light will blink, which means the powerline aapter 3 is checking the network N1.

 

? Please keep pressing the Pair/Reset button of the powerline adapter 1 for 1~3 seconds in 2 minutes, its  PLC light will blink, which means they are pairing automatically.

The powerline adapter 3 adds into the private network N1 successfully when   PLC light should be on stably.

3  The powerline adapter disconnects the private network.

n  For exampleThe powerline adapter 1, adapter 2 and adapter 3 have established the private network, but the powerline adapter 3 disconnects the private network.

The steps of setting:

Please keep pressing the Pair/Reset button of the powerline adapter 3 for up 6 seconds, its  PLC light will blink for three times, which means it disconnects the private network and restores to the factory default setting.

 

 

Was this article helpful to you?

Very Good(0)Article Views(360)