How to setup Wireless
WAN Function of F303
Product
line: wireless question category:
function config
Part 1: Login
the homepage of the router
Part 2: Setup connection type and LAN IP
Part 3: Enable
WISP mode
Part 4: Setup
secondary SSID and security key
The Topology is as
below:
Steps are as
following:
1.1 Login
to the management page of the router.
1.2 The
login password is admin, then click Advanced.
2.1 Click Advanced, then click Internet connection setup. Choose DHCP,
click Save.
2.2 Click Advanced,
and then click LAN Settings. Change your router’s LAN IP.(The LAN
IP address should be in different network segment.
For example, the router1 has the LAN IP 192.168.0.1, then
you can set the router2’s LAN IP as 192.168.1.1.)
3.1 Click Advanced and then choose WAN Medium Type, choose Wireless WAN, Click Open Scan.
3.2 Select the
Router1’s SSID, and input the router1’s security key. then click OK to
save the settings.
3.3 After
reboot, if the connection status shows connected and get the gateway of
uplink router, it means that you can have internet.
Note: After finish the Wireless
WAN settings, the primary SSID will become secondary SSID automatically.
4.1 Click Wireless and Wireless Basic Setting, change secondary SSID as you want,
and then click OK to save all the settings.
4.2 Click
wireless security key, select SSID which you have set as secondary SSID, choose
the security mode as WPA-PSK, input your security key, and
click OK to save all the setting.
Notice：If
you have other PC need to be get connected, please connect it to the one of the
LAN port or the wireless signal of the router. There is no need to configure
the router again.
