Product
line: wireless question category:
function config
Part 1: Login
the homepage of the router
Part 2: Setup LAN IP
Part 3: Enable
universal repeater mode
Part 4: Verify bridge connectivity
Part 5: Setup secondary SSID and security key
The Topology is as
below:
Steps are as
following:
1. Login to the
management page of the router.
2. Input login
username and password as admin, to login, then click Advanced.
1. Click Network,
and then click LAN. Change your router’s LAN IP.(The LAN
IP address should be different. For example, the uplink router has
the LAN IP 192.168.0.1, then you can set the secondary router’s LAN IP as
192.168.0.10)
1. Click Wireless
and then choose Wireless Extender, choose Universal Repeater
mode. Click Open Scan.
2.Select
your uplink router’s SSID, and input your uplink router’s security key. then
click Save to save the settings.
1.Connect
your PC to this Tenda wireless router via a wired or wireless
connection and set it to "Obtain an IP address automatically". If you
are not clear, see Appendix 1 Configure PC TCP/IP Settings .
2.Wait
until your PC successfully obtains an IP address.
3.Click
Start ->RUN;
4.
Enter cmd and click OK.
5.
Enter "ping default gateway IP address”. Here in this example, enter
"ping
192.168.0.1" and press Enter. If you see a similar screen (highlighted
area), the bridge is established successfully.
Note: After finish the universal
repeater settings, the primary SSID will become secondary SSID automatically.
5.1 Click Wireless and
Wireless Basic Setting, change secondary SSID, and then click OK to save the
settings.
5.2 Setup the security key
Click
wireless security key, select SSID which you have set as secondary SSID, choose
the security mode as WPA-PSK, input your security key, and
click OK to save the setting.
Notice：If
you have other PC need to be get connected, please connect it to the one of the
LAN port or the wireless signal of the router. There is no need to configure
the router again.
