Product
line: wireless question category:
function config
Part 1: Login
the homepage of the router
Part 2: Setup connection type and LAN IP
Part 3: Enable
WISP mode
Part 4: Setup
secondary SSID and security key
The Topology is as
below:
Steps are as
following:
1. Login to the
management page of the router.
2. Input login
username and password as admin, to login, then click Advanced.
1.Click
Advanced, then click Internet connection setup. Choose DHCP, click Save.
2. Click Advanced,
and then click LAN Settings. Change your router’s LAN IP.(The LAN
IP address should be in different network segment.
For example, the uplink router has the LAN IP 192.168.0.1, then you can set the
secondary router’s LAN IP as 192.168.10.1.)
1. Click Wireless and then choose Wireless Extender, choose WISP mode. Click Open Scan.
.
2.Select
your uplink router’s SSID, and input your uplink router’s security key. then
click Save to save the settings.
3.After reboot, if
the connection status shows connected and get the gateway of uplink router, it
means that you can have internet.
Note: After finish the
WISP settings, the primary SSID will become secondary SSID automatically.
4.1 Click Wireless and
Wireless Basic Setting, change secondary SSID, and then click OK to save the
settings.
4.2 Setup the security key
Click
wireless security key, select SSID which you have set as secondary SSID, choose
the security mode as WPA-PSK, input your security key, and
click OK to save the setting.
Notice：If
you have other PC need to be get connected, please connect it to the one of the
LAN port or the wireless signal of the router. There is no need to configure
the router again.
