How to setup WISP
mode for FH1202
Product
line: wireless question category:
function config
Part 1: Login
the homepage of the router
Part 2: Setup connection type and LAN IP
Part 3: Enable
WISP mode
The Topology is as
below:
Steps are as
following:
1. Login to the
management page of the router.
2. Input login
username and password as admin, to login, then click Advanced.
1.Click
Network, then click WAN. Choose Dynamic IP, click Save.
2. Click Network,
and then click LAN. Change your router’s LAN IP.(The LAN
IP address should be in different network segment.
For example, the uplink router has the LAN IP 192.168.0.1, then you can set the
secondary router’s LAN IP as 192.168.10.1.)
1. Click Wireless
and then choose Wireless Extender, choose WISP mode. Click Open Scan.
.
2.Select
your uplink router’s SSID, and input your uplink router’s security key. then
click Save to save the settings.
3.After reboot, if
the connection status shows connected and get the gateway of uplink router, it
means that you can have internet.
Notice：If
you have other PC need to be get connected, please connect it to the one of the
LAN port or the wireless signal of the router. There is no need to configure
the router again.
