A302-How to setup range extender mode via management page

How to setup range extender mode via management page

Model A302

We can set range extender mode for A302 to extend our wireless network via button or

management page based on web. This article will guide you set range extender mode via UI.

Before setting A302, please sure that you can get internet if you connect your computer to

upper router directly. Steps are as follow:

Part 1: Login its homepage

Part 2:  Configure extender function

 

1Launch a browser, and usually it will login automatically. If not, input 192.168.0.254 or

tendaextender.net in the address bar and press Enter.

2 Enter the default password admin and click OK.

3 Then the following page will appear.

 1 Click Wizard, select Range Extender Mode and click Next.

2Click Open Scan, select the remote router's wireless network (SSID), say Tenda_130518,

click OK and Close Scan.

3 Enter the remote device’s security key and click Save.

4 In the appearing dialogue box click OK

5 Click System Status to check the bridge status. When the bridge status displays

Connected, bridged successfully.

Note: If the wireless range extender is connected to the remote router within 20 seconds,

the wireless range extender’s DHCP server will be disabled automatically. Thus, the

wireless range extender will get the IP assigned from the remote router and then you can

access to the Internet. We can still login its homepage with”tendaextender.net”.

How to set up range extender mode by button? Click here.

  • Категория документа : Function Config
  • Сопутствующие товары : A302

Была ли эта статья полезна?

Отлично!(2)Просмотры статьи(7609)